• Largest build envelope of 36 x 24 x 36 inch (914 x 610 x 914 mm)
• Highest throughput - 2.2 x faster than the Fortus 200mc
• Precision ball screw technology for increased accuracy, repeatability, and reliability
• Holds the most material volume
• Based on material, manufactured parts can be used for high heat applications 

System Size (XYZ):

• 109.1 x 66.3 x 79.8 inches ( 2772 x 1683 x 2281 mm) 

System size with manufacturing light tower (XYZ):

• 109.1 x 66.3 x 89.8 inches (2772 x 1683 x 2281 mm) 

Build Envelope: 

• 36 x 24 x 36 inch (914 x 610 x 914 mm)
• The system will accept two build sheet sizes:
  -- 36 x 24 x 36 inch (914 x 610 x 914 mm) build sheet or
  -- 16 x 14 x 16 inch (406 x 356 x 406mm) build sheet

Build Materials:

• ABS-M30 thermoplastic 
• ABS-M30i thermoplastic
• PC-ABS thermoplastic
• PC-ISO thermoplastic
• PC thermoplastic
• ULTEM* 9085 thermoplastic
• PPSF thermoplastic

Achievable Accuracy:

• Parts are produced within an accuracy of +/- .0035 inch or +/- .0015 inch per inch(+/- .089 mm or +/- .0015 mm per mm whichever is greater).***
  

Network Communication:

• 10/100 base T connection. Ethernet protocol 

Operating Environment:

• Maximum room temperature of 85°F (29.4°C)
• Maximum room humidity of 80%.

Power Requirements:

• 230VAC nominal 3-phase service with 5% regulation.
  *230VAC as measured phase-to-phase.
• 50 Hz or 60Hz
• 40 Amp circuit

Software:

• Insight^TM 
• Control Center^TM
• FDM TEAM^TM (optional advanced software)

 *Materials will be available Q2 - 2009
**ULTEM 9085 is a trademark of SABIC Innovative Plastics IP BV
***Note: Accuracy is geometry dependent. Achievable accuracy specification derived from statistical data at 95% dimensional yield. See Fortus 900mc accuracy white paper for more information.